FixTheBog proudly supports Snoap — refillable, eco-friendly soap systems built to reduce plastic waste. Shop Snoap

Tesla

Tesla TS220 7 Inch Dual Safety Immersion Thermostat FTB1446

Tesla

Tesla TS220 7 Inch Dual Safety Immersion Thermostat FTB1446

SKU:
FTB1446
UPC:
9792138412
Shipping:
Calculated at Checkout
£16.80
Adding to basket… The item has been added
Item Description

 

Tesla UK 7 Inch Dual Safety Immersion Thermostat — TS220

Tesla UK Range 7 Inch Stem Dual Safety Resettable

The Tesla UK TS220 (Internal SKU: FTB1446) is a 7 inch resettable dual safety rod thermostat designed for electric immersion heaters used to heat stored domestic hot water cylinders independently of a central heating boiler. Supplied for new immersion heater installations or direct replacement of a faulty thermostat, it regulates stored water temperature and provides a manual resettable over-temperature safety cut-out.

Identification & Technical Guide:
Brand: Tesla UK | MPN: TS220 | Internal Reference: FTB1446 | Key Dimensions: 7 Inch (177.8mm) Stem Length | Material & Finish: Plastic Head / Brass Stem Finish | Compatibility: Immersion heaters accepting a 7 inch dual safety rod thermostat

Key Features

  • 7 Inch Dual Safety Resettable Design: Combines primary temperature control with a resettable high-limit thermal safety cut-out.
  • Independent Stored Water Heating Control: Regulates electric immersion heaters operating independently of the main boiler system.
  • Plastic Control Head & Brass Finish Stem: Engineered for straightforward replacement during immersion heater servicing or installation.
  • Genuine Tesla UK Component (TS220): Part of the Tesla UK heating and hot water controls range.

Installation & Compatibility Notes

Length Verification (7 Inch Only): Confirm your existing immersion heater thermostat pocket requires a 7 inch stem before ordering (do not fit a 7 inch thermostat into an 11 inch or 18 inch immersion pocket unless specified by the immersion heater manufacturer).

Electrical Safety & Fitting Advice: Isolate the mains electrical supply at the double-pole switch/consumer unit and prove dead before removing the immersion heater terminal cover. Slide the new TS220 rod fully into the dry pocket, secure the live and neutral leads firmly to the marked terminals, and verify the temperature dial setting before restoring power.

Need help figuring out if this product is right for your setup?

Send us your best bathroom selfies (or, you know, just your bathroom setup pics) to [email protected] or WhatsApp 07359 625424 us, and we'll help you flush your confusion away!

Same Day Despatch Weekdays For Orders Placed By 2pm. DHL Cut Off Weekdays Noon.