Ideal Standard Domi 760 / 762 Spout O-Ring — A962986NU
The Ideal Standard A962986NU is an authentic factory replacement elastomeric O-ring seal designed specifically for the swivel spout assembly on Domi 760 and Domi 762 mixer taps. Over time, friction from rotating the spout combined with hard water limescale causes original rubber seals to wear, flatten, or degrade. Installing this genuine OEM O-ring creates a watertight dynamic seal around the spout spigot, eliminating leaks and seepage around the base collar when the tap is running.
Identification Guide:
MPN: A962986NU | Old Barcode (EAN): 5055639184268 | Compatible Ranges: Domi 760 & Domi 762 Series | Material: Synthetic Elastomer (EPDM Rubber) | Finish: NU (Neutral / Self-Colour Rubber)
Key Features
- Original OEM Specification: Guarantees the correct cord cross-section and diameter to seat precisely in the factory spout groove.
- Resolves Base Leaks: Specifically targets water pooling around the swivel joint or running down into the sink cut-out.
- Durable Synthetic Rubber: Formulated for continuous swivel motion, temperature fluctuations, and water-treatment resistance.
- Cost-Effective Maintenance: Restores full watertight functionality without needing to replace the entire brass spout or tap body.
Installation Note
Isolate the tap supply before servicing. Loosen the retaining grub screw or collar securing the spout to the tap body and lift the spout vertically off its base spigot.
Fitting Tip: Thoroughly clean away any limescale or debris from the groove and inner bore of the spout. Apply a thin coating of WRAS-approved silicone grease to the new O-ring prior to reassembly to prevent pinching and ensure smooth swivel rotation.