SIAMP — Optima 50 Flush Valve Cable — 750 mm — 34495709
Genuine cable assembly for the SIAMP Optima 50 dual-flush valve. Cable length 750 mm. Use to replace a stretched, frayed or broken pull cable between the operating button and the Optima 50 valve top.
Key features
- Genuine SIAMP 34495709 cable assembly.
- For the Optima 50 dual-flush valve head.
- Cable length: 750 mm (measure your old cable end-to-end).
- Quick swap: unclips at the button and valve top (no need to remove the cistern in most cases).
- Fixes short flush not engaging, button feeling slack, or no flush.
How to confirm it’s the right cable
| Check | What you should see |
|---|---|
| Valve model | Flush valve body/top stamped or documented as Optima 50. |
| Actuation type | Mechanical cable from button to valve (not rigid rods, not an air tube). |
| Cable length | Approx. 750 mm overall (tip-to-tip, including end fittings). |
| Ends/connectors | Ends match the Optima 50 valve cap and your button carrier (compare to product photos). |
Tip: If your button uses rigid rods or a pneumatic tube, this is not the right part.
Does not fit
- SIAMP Optima 49 / Optima 51 or other SIAMP valves.
- Pneumatic/air button systems (air hose, no cable).
- Rod-operated push buttons (solid plastic/metal rods).
- Buttons/plates from other brands that don’t use the Optima 50 cable interface.
Specification
- Brand: SIAMP
- Part code: 34495709
- Model compatibility: Optima 50 flush valve
- Type: Mechanical cable assembly
- Length: 750 mm (nominal)
- FixTheBog code: FTB11604
- Pack contents: 1 × cable (no button or valve body included)
Fitting notes (at your own discretion)
- Isolate water; lift cistern lid.
- Note the cable routing; photograph if helpful.
- Unclip at the button housing and at the valve top; remove cable.
- Clip the new cable in the same orientation; route without tight bends.
- Test both full and half flush; ensure button returns freely.
If the button still feels slack, check the cable path for kinks or the button carrier for damage.
Questions & Answers
Will this fit my SIAMP valve?
Only if your valve is a SIAMP Optima 50 with a mechanical cable and you need the 750 mm length. It won’t fit Optima 49/51, pneumatic systems, or rod-operated buttons.
How do I tell if mine is Optima 50?
Look for “Optima 50” on the flush valve top/body, or compare your valve cap and cable ends to the product images. Optima 50 uses a pull cable from the button to the valve head.
What problems does a new cable fix?
A stretched/frayed cable causes weak flush, only one button working, or no action. Replacing the cable restores correct travel.
Do I need a different length?
Measure your old cable end-to-end. If it isn’t ~750 mm, this isn’t the one. Order the length that matches your installation.