FixTheBog proudly supports Snoap — refillable, eco-friendly soap systems built to reduce plastic waste. Shop Snoap

Tesla

Tesla TS225 11" Dual Safety Immersion Heater Rod Thermostat 16A

Tesla

Tesla TS225 11" Dual Safety Immersion Heater Rod Thermostat 16A

SKU:
FTB1447
Shipping:
Calculated at Checkout
Item Description

 

Tesla 11" Dual Safety Immersion Thermostat — TS225

Genuine Tesla Part Dual Safety Cut-Out 11" (280mm) Stem Length

The Tesla TS225 is an authentic 11-inch (280mm nominal) plug-in rod thermostat engineered for domestic immersion heating elements in both vented and unvented hot water storage cylinders. Conforming fully to BS EN 60730-2-9 safety standards, it combines an adjustable primary cycling temperature control dial with an independent, fail-safe manual-reset secondary high-limit thermal cut-out to protect against dangerous cylinder scalding and overheating.

Identification & Technical Guide:
Brand: Tesla UK | MPN: TS225 | Internal Reference: FTB1447 | Stem Length: 11 Inches (280mm nominal) | Stem Diameter: Standard 8mm brass/copper sensing sheath | Electrical Rating: 16A @ 250V AC (Up to 3kW load) | Compliance: BS EN 60730-2-9 (European Safety Standard)

Key Features

  • Dual-Function Safety Protection: Integrates an adjustable primary temperature control thermostat with an independent, non-self-resetting secondary high-limit thermal trip.
  • Integrated Manual Reset Button: In the event of welded main contacts or water overheating, the secondary cut-out trips open and locks until manually reset via the recessed safety pin.
  • Extended 11" Thermo-Pocket Reach: Purpose-built for full-depth 11" element pockets to ensure accurate core water temperature reading throughout the cylinder body.
  • Heavy-Duty 16A Switching: Engineered to handle standard UK 3kW domestic immersion heater element loads running on 230V/240V mains circuits.

Installation & Compatibility Notes

Pocket Depth Verification: Verify the internal thermo-pocket depth of your existing immersion heater element prior to ordering. This model has an 11-inch (280mm) stem. If your pocket is 7 inches (178mm), you require the shorter Tesla TS220 instead; forcing an 11" rod into a 7" pocket will leave terminals exposed and prevent the protective terminal cap from fitting.

Fitting Advice: Always isolate the electrical supply at the double-pole fused spur before removing the immersion cover. Slide the thermostat probe cleanly down the pocket until the terminal spade/screw base sits completely flush. Ensure terminal screws are securely torqued to avoid loose connections, terminal resistance overheating, or arcing.

Compatible Replacement Applications

  • Direct Replacement: Cotherm TSE00136 / TSE00188 (11"), Sunvic, Backer, and Diamond rod thermostats with 11" (280mm) probe pockets
  • Associated Heating Elements: Standard 1-3/4" BSP (~59.6mm OD) and 2-1/4" BSP (~65.7mm OD) copper, Incoloy, or titanium immersion heaters with deep pockets
  • Cylinder Compatibility: Vented copper cylinders, unvented thermal stores, Megaflo, Telford, Gledhill, and Santon domestic hot water systems

Need help figuring out if this product is right for your setup?

Send us your best bathroom selfies (or, you know, just your bathroom setup pics) to [email protected] or WhatsApp 07359 625424 us, and we'll help you flush your confusion away!

Same Day Despatch Weekdays For Orders Placed By 2pm. DHL Cut Off Weekdays Noon.